Heat Exchanger

This module is for design/simulation of various type of heat exchangers viz. Shell & Tube, Finned Tube, Double Pipe etc. The program automatically takes care of phase change calculations and carry out calculations for Boiling, Condensation etc.

 

 

Calculate Surface Area

Once all the data has been entered, this is used to calculate the performance of the heat changer.

Simulate Exchanger performance
For a specified heat exchanger details and process fluid parameters at the inlet of exchanger, this will simulate the exchanger performance and give the outlet streams after heat transfer.

 

  Temperature Profile
This module also takes care of heat balance just as before. Only thing is that you have to fill in details of shell side stream and tube side stream for inlet as well as outlet. You can leave the value to be calculated as zero. In case of simulation you can leave the value of both outlet emperatures as zero. Depending upon number of degrees of freedom, the program does the heat balance. In heat exchanger module you can try lot of things, including graphical temperature profile etc.